Care and Cleaning/continued/
Oven Lamp Replacement
CAUTION: Before replacing your oven bulb, dis- connect electrical power to the range at the main fuse or circuit breaker panel. Be sure to let the lamp cover and bulb coo! completely,
The oven lamp (bulb) is covered with a removable
glass cover that is held in place with a
To remove:
1, Hold hand under cover so it doesn't fall when
released With fingers of same hand. firmly push back wire bail until it clears cover, Lift off cover. DO NOT REMOVE ANY SCREWS TO REMOVE COVER.
2.Replace bulb with a
To replace cover:
1.Place it into groove of lamp receptacle. Pull wire bail forward to center of cover until it snaps into place, When in place, wire holds cover firmly. Be certain wire bail is in depression in center of cover
2, Connect electrical power to the range.
Surface Light and Starter
(On models so equipped)
CAUTION: Do not touch the bulb with wet hands
or when bulb is hot, Never wipe the light area with
a wet cloth. Electrical power must be shut off if you have to replace a bulb.
To replace bulb:
Liftup 1. Flip front of the hinged canopy up,
2. Remove fluorescent light bulb Replace the bulb with one of the same length and wattage,
3. Lower the canopy.
To replace starter:
1.Open canopy and remove bulb as explained above,,
2.Grasp starter, turn it counterclockwise about one- quarter turn and lift out. Replace with one of the same wattage,
3.Reposition bulb and lower the canopy,
34
