SOYO SOYOTM manual IR Transmission Delay, IR IRQ Select, FIR Mode Use DMA, Onboard Parallel Port

36 BIOS Setup

IR Transmission Delay	Choose Enabled (default) or Disabled.
	Due to the various design of IR devices,
	transmission delay has to be added on
	for different protocol.
IR IRQ Select	Choose IRQ3, IRQ4 (default), IRQ10, or
	IRQ11. If you have IRQ conflict
	problem during using the IR device,
	select another IRQ then try again.
FIR Mode Use DMA	Choose Disabled, 0, 1, or 3. When you
	choose FIR in IR Mode, you need to
	select a DMA channel to make the FIR
	transmission work.
Onboard Parallel Port	Choose the parallel port I/O address:
	378H/IRQ7 (default), 3BCH/IRQ7,
	278H/IRQ5, or Disabled to disable this
	port.
Parallel Port Mode	Choose ECP+EPP (default), SPP, EPP,
	or ECP. The mode depends on your
	external device that connects to this port.
ECP Mode Use DMA	Choose DMA3 (default) or DMA1.
	This setting only works when the
	Onboard Printer Mode is set at the ECP
	mode.
EPP Mode Select	Choose EPP1.9 (default) or EPP1.7.
	Check with your parallel port device
	provider to select the right mode.

3.After you have finished with the Integrated Peripherals, press the <ESC> key and follow the screen instructions to save or disregard your settings.