SOYO SY-K7VEMPRO V1.0 quick start CPU FSB Setting JP3

Hardware Installation

SY-K7VEMPRO V1.0 Quick Start Guide

the CPU fan pins, get their revolution information and send it to the BIOS.

(2)Auto Power Off System: If the BIOS gets the information of CPU fan revolution, it goes on working normally. If not, it will inform the system and have the power supply disconnected immediately. Thus, the CPU is protected from over heating.

Note: The following must be observed to secure the normal functioning of “Fan-Off Control”:

1.CPU fan with sensor pins must be used.

2.CPU fans approved by AMD are strongly recommended.

3.The “HOT KEY” function is provided for the CPU fans without sensor pins, to avoid the power off. Users may press the “Insert” key to jump over the “Power Off” mode; go to the BIOS and disable “FOC”. Now system can be booted normally.

4.The power connector of the CPU fan must be connected to the specified “CPU Fan Connector” on the motherboard to secure the normal functioning of the system.

We provide the following User-Friendly protection features:

1.Fan-Off Control : The motherboard detects the status of the CPU fan and protects the CPU by automatically disconnecting the power supply. The default value of this function is Enable. After booting up, the user may disable it.

2.CPU Socket Sticker : Users will find a sticker on the CPU socket, which reminds them of the correct usage of the K7 CPU.

3. Heat Dissipation Paste: Heat Dissipation Paste is included for all Socket-A motherboards, to enhance the heat dissipation capability.

Furthermore, we strongly recommend our users to enable the function of H/W monitoring in the BIOS. This function, together with the FOC, provides the total protection to the CPU and allows it to maximize its performance.

Step 2. CPU FSB Setting (JP3)

Refer to the following table:

CPU FSB Setting

200MHz (Default)

266MHz

JP3

Short Pin2-3

1 2 3

Short Pin1-2

1 2 3

10