STEP 5: Connect Scanner to Pocket PC via Bluetooth
1.Turn on the Cordless Hand Scanner. Press the small power button on the handle of the scanner for five seconds, until you see the LED turn blue. The LED should blink blue once every second to show that the Bluetooth radio is on but not connected. If the LED begins blinking red, the battery needs to be recharged.
WARNING: Do not use the Cordless Hand Scanner when it is being charged, or the battery may have problems achieving a full charge in the future.
2.Prepare the Bluetooth hardware for your Pocket PC. If using the Socket SDIO or CF card, insert it into your device. Make sure the Bluetooth radio is turned on.
Refer to the documentation for your Bluetooth hardware for instructions.
3.Start SocketScan. Tap Start Programs SocketScan.
4.The SocketScan icon should appear in the task tray 
(visible in the Today screen), indicating that your device is not currently connected to the CHS. Tap on the icon. In the
Important!
Your Pocket PC cannot connect to the CHS if you have another device assigned as your favorite or default Bluetooth serial device. If necessary, remove any settings that designate another device as your favorite or default Bluetooth serial device.
If the Connect CHS option does not appear, use the Socket CHS configuration utility to enable SocketScan for use with the CHS. See Step 4 on the previous page.
CHAPTER 2: SETUP FOR WINDOWS MOBILE | 11 |