1.Turn OFF the power to your computer and any other connected peripheral devices.
2.Unplug the power cord from the back of the computer, remove the cover.
3.Remove the slot bracket from an available PCI slot.
4.To install the card, carefully align the card's bus connector with the selected PCI slot on the motherboard. Push the board down firmly, but gently, until it is well seated.
5.Replace the slot bracket holding screw to secure the card.
6.Replace the computer cover and reconnect the power cord.
Hard Disk Drive Connection
The SATA
RAID Arrays
RAID Arrays are setup in the SATA
RAID 0 (Striping)
This RAID array to be used on New/Blank hard drives. Striping will destroy existing data on the hard drives.
1.As the BIOS boots press Ctrl+R when prompted to enter the RAID BIOS.
2.At the next screen select RAID , then press Enter.
3