SIIG 04-0265F To Verify Windows 98SE/ME Installation, For Existing Windows ME Installation

6.Check Specify a location, uncheck the other box, type D:\ME, click Next. (Change D: to match the drive letter of your CD-ROM)

7.Click Next, then click Finish. Remove the driver CD and restart Windows to complete the installation.

For Existing Windows ME Installation

1.Install the board and boot up Windows ME.

2.At the Add New Hardware Wizard, insert the driver CD.

3.Select Specifythelocationofthedriver(Advanced), then click Next.

4.Check Specify a location, uncheck the other box, type D:\ME, click Next. (Change D: to match the drive letter of your CD-ROM)

5.Click Next, then click Finish.

6.Remove the driver CD and restart Windows to complete the installation.

To Verify Windows 98SE/ME Installation

1.Right-click My Computer, then click Properties. Select Device Manager tab.

2.Double click SCSI controllers, Silicon Image SiI...

Controller should be listed.

3.Double click Silicon Image SiI... Controller and click Properties. A message This device is working properly is displayed in the dialog box when the driver is correctly installed.

6