Sega 999-0988, Star Wars Racer Arcade owner manual Installation Precautions

Page 7

Safety Check: Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

Heat: The product should be situated away from heat sources such as radiators, heat registers, stoves, or other prod- ucts (including amplifiers) that produce heat.

Lithium Battery- Dispose of batteries only in accordance with the battery manufacturer’s recommen- dations. Do not dispose in an open flame condition, since the battery may explode.

Cleaning: When cleaning the monitor glass, use water or glass cleaner and a soft cloth. Do not apply chemicals such as benzine, thinner, etc.

Location: This an indoor game machine, DO NOT install it outside. To ensure proper usage, avoid installing indoors in the places mentioned below:

Places subject to rain/water leakage, or condensation due to humidity;

In close proximity to a potential wet area;

Locations receiving direct sunlight;

Places close to heating units or hot air;

In the vicinity of highly inflammable/volatile chemicals or hazardous matter;

On sloped surfaces;

In the vicinity of emergency response facilities such as fire exits and fire extinguishers;

Places subject to any type of violent impact;

Dusty places.

INSTALLATION PRECAUTIONS

Verify the amperage of the branch circuit outlet before plugging in the power plug. Do not over- load the circuit.

Avoid using an extension cord. If one is required, use an extension cord of type SJT, 16/3 AWG rated min. 120 VAC, 7A.

Moving this unit requires a minimum clearance (of doors, etc.) of 32” (W) by 77” (H).

For the operation of this machine, secure a minimum area of 32” (W) by 42”(D).

REGULATORY APPROVALS

This game has been tested and found to comply with the Federal Communications Commission Rules.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This game has been tested and listed by Underwriters Laboratories, Inc., to ANSI/UL22.

5

Image 7
Contents Mini DX Warranty Page Page Sega ENTERPRISES, INC. USA General Precautions Installation Precautions Precautions to be Heeded for Operation Precautions to be Heeded During Operation Name of Parts Tool AccessoriesKEY Description KEY Master Tamperproof WrenchNever Ship Hikaru Game Boards Outside of Cage Assy of Cabinet Assembling and InstallationSecuring in Place Adjuster Adjustment Power Supply Memory Test Assembling CheckInput Test Sound TestOutput Test Precautions to be Heeded When Moving the Machine Contents of Game HOW to Play For Communication Play Boonta Classic Expert Bantha Tracks EasySMUGGLER’S Cove Normal Pixelito Challenge HardBrake and Lever Used jointly Game Screen Name Entry Password System Test Mode Speaker Volume Super Woofer Switch Unit and Coin MeterSwitch Unit Speaker Volume SpeakersRAM Test System Test Mode MenuJVS Test R.T. Test Sound TestIndividual System AssignmentsCommon Seat Number Coin Assignments Setting Example Manual SettingCoin to Credit Bonus Adder Coin Chute #1 Multiplier COIN/CREDIT Setting Setting No Coin Counts AS Multiplier Coins Each SEAT’S Coin ChuteSequence Setting Bookkeeping Backup RAM Clear Rombd Test Game Test Mode Clock SettingGame Menu Game Test ModeInput Test Recommended Volume ValueOutput Test This case the cabinet is set to Slave Game AssignmentsThis case the cabinet is set to no Link Play Time Number of GamesTime Histogram Calibration Test Features Backup Data ClearControl Panel Grip 10 1 Removing the Control Panel CoverGrip END Grip PIN10 2 Volume ADJUSTMENT/REPLACEMENT AdjustmentVolume ReplacementApply Greasing to the Assy Mecha Lever 10 3 GreasingApply Greasing to the Assy Brake Handling the Coin JAM Coin SelectorHole Position Optional Dollar Bill AcceptorPage Coin door shown with optional dollar bill validator inserted Primary side and secondary side Monitor12 2 Cautions to be Heeded When Cleaning the CRT Surfaces 12 3 Adjustment Method Fluorescent Lamp Replacing the Fluorescent Lamp and ButtonsStart Button and View Change Button Periodic Inspection Table Cleaning the Cabinet SurfacesDesign Related Parts VOL Cont B-5K OHM Parts List Switch UnitSW Brkt Sticker SW UnitAssy AC Unit DRT1-0400 Assy Seat Assy Controller Assy Brake Start Switch IMPERIAL#57-2000-30Assy Lever Mecha Boost Button IMPERIAL#54-0004-12Assy Lever Mecha Front ViewStopper Rubber Lever Adjust GearLever Brkt Inner Lever ShaftDisk Inner Rory Dampr STW Mini Spring Rotary Dampr STW Mini Item no Description Wire Color Table Visit OUR Website