Identify - Pressing [ 
- ] will cause the gobo changer, whose status you are viewing, to initialize.
SETUP
This menu is used to display and select the starting DMX channel as well as other operating modes.
Pressing [ 
- ] at any of the following options will bring up a question mark (?) behind the option. Pressing [ + 
] and [ 
- ] will increment and decrement numbers such as channels or toggle options such as on or off. Pressing [ 
/Enter ] will confirm your selection and the question mark will go away.
[ 
- ]
Chan 001 - This allows you to select the first channel of the DMX channel block which the Power Supply will respond to.
[ 
/Enter ]
Mode CR2 - This selects original Coloram 1 (12 channel mode - CR1) or Coloram II (24 channel mode - CR2). This option must be set to CR1 to work with original Coloram I color changers which have not had the Coloram II software upgrade.
[ 
/Enter ]
Tbck OFF - This option turns talkback to a remote status monitor on or off. Status of the color changers or gobo changers will still be displayed in the status menu. If this is turned on, the first channel of the power supply's DMX channel block is limited to 1, 4, 7, 10, 13, 16, etc.
[ 
/Enter ]
Jttr OFF - This option turns the jitter filter on or off. This option may be necessary for AMX to DMX converters which can have LSB jitter.
[ 
/Enter ]
DMXF OFF - DMX fan control channel. This enables or disables the lighting console fan speed control. This can be OFF (do not control the fans via a DMX channel), ONE (select one DMX channel to control all the color changer fans connected to that power supply) or BLK (select a BLOCK of DMX channels - one DMX channel for each channel of the power supply (12 channels for a 12 way power supply).
If you use BLOCK, do not mix single channel Coloram IIs and
12