Power Supply
The power supply converts the DMX512 signal level from the lighting console into Coloram I/Coloram II control signal which it then sends to each color changer along with 24 volts DC. The power supply features a DMX bypass relay to pass the DMX signal to the DMX output connector in the event of AC power loss.
The power supply features an 8 character LED display and three selector buttons. This user interface is used to select the starting DMX channel, set operating modes, send remote commands to the color changers and view color changer status.
Coloram II Cable
The Coloram II Cable connects the Coloram II Power Supply outputs to the Coloram II Color Changers or other products and provides them with power and control signal. The Coloram II Cable uses
Note: Colroam II Cable is used in the Coloram II System and in the Forerunner System. It may be referred to as either Coloram cable or Forerunner cable.
The Coloram II Power Supply menu
This section describes the power supply menu.
The following diagram is the eight character display and the three push buttons:
DISPLAY
/ENTER 
+ 
_
The following diagram is an overall view of the power supply menu structure:
6