It is important to note that if the power supply is at its current limit (but not exceeded), it will not "check in" any other units and the "Overload" message will not be displayed.
"DMX
"Fan Chan" - This is similar to the "DMX Chan" explanation above but applies to the fan DMX channel or fan DMX channel block.
To read the above "alert messages", do the following:
1.When *ALERT* is being displayed, press 
/Enter . Then the number of alert messages will be displayed.
2.As an example: "2 ALERTS" indicates there are 2 problems (alerts).
3.Press "t" button to get more information on the alerts.
4.As an example: "Pstn 001" indicates the head unit #1 has a position error.
5. | Press | /Enter to get information on other alerts. |
6.Viewing the alerts in this manner also "clears them" unless the problem currently exists.
XXUNITS
This is commonly referred to as the status menu. It displays the number of color changers, CXIs and/or other Coloram II components connected the power supply.
Press [ 
- ]
DMX 001 - Pressing [ 
/Enter ] allows you to select the DMX channel of the color changer or gobo changer which you wish to view the status of. Only channels with color changers or gobo changers set to them will be displayed.
Press [ 
- ]
1 of 1 - Pressing [ 
/Enter ] allows you to select a specific color changer or gobo changer if more than one color changer or gobo changer is set to that channel.
Press [ 
- ]
For the Coloram II color changer:
ColoRAM - Indicates there is a color changer addressed to this channel.
[ 
/Enter ]
9