Bypass Tray Paper Type, Original Size Detect

Dol_Chapter-2 Page 17 Thursday, July 19, 2001 3:22 PM

Settings You Can Change with the User Tools

❒When Translucent Paper modes 1 or 2 are selected, and you change the pa- per type from Plain or Film to Translucent Paper, it may take longer for the machine to get ready for copying. (Up to two minutes).

❖Bypass Tray Paper Type

Specifies the thickness for the paper in the bypass tray. If the image on copies is scratched, or the paper wrinkles when using translucent paper, you can change the setting to get better copies.

Select Plain, Translucent Paper, or Film.

Note

❒For a guide to paper thickness, see the p.16 “Fusing Adjustment: Paper Tray” chart. However, the results for hemmed paper cannot be guaranteed.

Note

❒Default: 3

❒The paper thickness can be set from 1 (Thicker) to 5 (Thinner).

❖Original Size Detect

Specifies whether the scanning area when detecting the size of an original.

• Metric version

•A Series

•JIS B Series

•Inch version

•Engineering

•Architecture

Note

❒Default:

•Metric version: A series

•Inch version: Engineering

❒When you change the setting, the following changes are made to the User Auto R/E Original Size Detect setting in User Tools (Copier Features).

❖ Metric version

•For A series→JIS-B series, if B1 is set for the User Auto Reduce/En- large settings, the User Auto R/E Original Size Detect setting is changed to vertical.

•B series→JIS-A series, if A0 is set for the User Auto Reduce/Enlarge settings, the User Auto R/E Original Size Detect setting is changed to vertical.

❖Inch version

When switching Engineering ↔ Architecture, if E is set for the User Auto Reduce/Enlarge settings, the User Auto R/E Original Size Detect Setting is changed to vertical.