Viking 56K manual Windows NT

Page 20

VIKING COMPONENTS 56K EXTERNAL MODEM USER’S GUIDE

Windows NT 4.0 (Continued):

5.Insert the diver diskette that was included with your modem. (If the diskette was not included or lost,the drivers can be downloaded from our Web site) Select your floppy diskette drive at the bottom of the window and click on the “OK”but- ton.

6.Select the “Viking V.90+K56Flex EXT Modem” below the “Models” section on the window. Then click on the “OK”button.

18Chapter 3

Image 20
Contents Viking 56K External Modem Table of Contents Introduction Data ModemBefore You Install System RequirementsPhone Line Requirements Communications Software requirementsInstallation Hardware InstallationHardware Installation Turn on your computer and any attached devices Software Installation Mac OS 7.5.3 or LaterYour driver installation is now complete MacComCenter Communication Software Your MacComCenter software installation is now complete Remote Access/Mac PPP Setup Free PPP SetupWindows 95 Software Windows 98 Software Windows 98 Software Your installation is now complete Windows NT Windows NT Windows NT Windows NT Your installation is now complete Using Data and Fax Communication Software Changing the modem Initialization StringTechnical Notes Status Light DefinitionsChanging the IRQ Settings Windows 95 & 98 COM Ports and IRQ SettingsIdentifying COM Port Settings Chapter Problem Solution GeneralATL0 Mac OS 7.5.3 or Later Connection Scripts Mac OS 7.6 or LaterGuidelines Basic AT CommandsBasic AT Command Set Error Detected, No Answer Disable guard tone Initiate local analog loopback +MS ECC Commands MNP 10 CommandsClass Commands Caller ID CommandsFax Class +FET=N Modem Driver & Firmware Upgrades Contacting Technical Support Viking Components Technical Support Phone NumberCommunication Regulations Industry Canada IC NoticePart 68 Requirements Part 68 Requirements Warranty & Disclaimers Year Warranty