Viking 56K manual Disable guard tone

VIKING COMPONENTS 56K EXTERNAL MODEM USER’S GUIDE

Basic AT Command Set (Continued)

Command	Function
&G0	Disable guard tone.
&G1	Disable guard tone.
&G2	Enable 1800 Hz tone.
&J0	Set S-Register response only for compatibility.
&J1	Set S-Register response only for compatibility.
&K0	Disable DTE/DCE flow control.
&K3	Enable RTS/CTS DTE/DCE flow control.
&K4	Enable XON/XOFF DTE/DCE flow control.
&K5	Enable transparent XON/XOFF flow control.
&K6	Enable both RTS/CTS and XON/XOFF flow control.
&L0	Select dial up line operation.
&L1	Select leased line operation.
&M0	Select direct asynchronous mode.
&M1	Select sync connect with async off-line command mode.*
&M2	Select sync connect with async off-line command mode and enable DTR of
	directory zero.*
&M3	Select sync connect with async off-line command mode and enable DTR to
	act as Talk/Data switch.*
&P0	Set 10 pps pulse dial with 39%/61% make/break.
&P1	Set 10 pps pulse dial with 33%/67% make/break.
&P2	Set 20 pps pulse dial with 39%/61% make/break.
&P3	Set 20 pps pulse dial with 33%/67% make/break.
&Q0	Select direct asynchronous mode.
&Q1	Select sync connect with async off-line command mode.*
&Q2	Select sync connect with async off-line command mode and enable DTR
	dialing of directory zero.*
&Q3	Select sync connect with async off-line command mode and enable DTR to
	act as Talk/Data switch.*
&Q4	Select Hayes AutoSync mode.
&Q5	Modem negotiates an error corrected link.
&Q6	Select asynchronous operation in normal mode.
&R0	CTS tracks RTS (async) or acts per V.25 (sync).
&R1	CTS is always active.
&S0	DSR is always active.
&S1	DSR acts per V.25.
&T0	Terminate any test in progress.

*Serial Interface operation only.

31Chapter 6