Jumper Settings
There are five jumper locations, which vary slightly depending on which network interface option is selected. Their functions are as follows:
JP1 SERVICE
Momentarily shorting this jumper causes the Neuron chip to broadcast its Neuron ID across the network. This jumper should normally be left open.
Default: OPEN
JP2 RESET
Momentarily shorting this jumper asserts the
Default: OPEN
JP3 TERMINATION
This jumper controls whether or not the onboard termination circuit is enabled or disabled.
Shorted | Termination is enabled. |
Open | Termination is disabled. |
Please see page 7, “Cable Grounding and Termination” regarding termination issues.
Default: | OPEN (no termination) |
JP4 I/O ADDRESS
This jumper selects the I/O address range used by the
Position 1 Address
Position 2 Address
Position 3 Address
Position 4 Address
Default: | Position 1 |
3