Z Microsystems 14 manual Final Adjustments of the Command Console

Page 10

Install Console

FINAL ADJUSTMENTS OF THE COMMAND CONSOLE

Loosen the screws on each of the front Z-Lock mounts.

Slide the Console partially out.

Use a flathead screw driver to slightly move the Z-Locks out away from the Console.

Tighten all the screws on the front Z-Lock mounts.

Slide the Console in and out to see if it moves smoothly.

Go back to the rear of the rack and fully tighten the slide extension rail screw ((U) see page 30 - Install hardware ).screws.

Note: A wrench may be necessary to hold the nut on the other side.

10

Doc# 27-0001UM Issued 7/99 Rev. 1.2

Image 10

Contents Command NS OLE Regulatory FCC InformationContents Shipment Contents System RequirementsProduct Description Starting Point PrecautionsTools Required Install the Slides in the Cabinet Frame Install RailsSlide Removal Install Rails Install the Command Console in the Slides Install ConsoleTest Installation and Make Adjustments Final Adjustments of the Command Console Setup Setting UP the Monitor Keyboard and MouseClosing Console Closing Down the MonitorOperation Monitor Adjustments ON-SCREEN DisplayMenu Descriptions Size Auto Calibration Program LED Indicator Timing Guide ReferenceIf using Macintosh, need Mac adapter Troubleshooting Troubleshooting Specifications Appendix PIN AssignmentSupport Further HelpReplacing Parts Providing FeedbackCompliance Y2K ComplianceDrawings Drawings Install Hardware Command ConsoleDoc# 27-0001UM Issued 7/99 Rev Doc# 27-0001UM Issued 7/99 Rev Microsystems, Inc