Z Microsystems 14 manual Reference, LED Indicator Timing Guide

Page 18

Reference

LED INDICATOR

TIMING GUIDE

The Power Management feature of the LCD monitor is comprised of three stages:

1.On (green)

2.Standby, Suspend or Active Off (amber/green)

3.Out of Range (amber)

The monitor is a multi-frequency monitor. It operates at horizontal frequencies between 31.25KHz and 60.24KHZ, vertical frequencies between 56Hz and 75Hz. Because of its microprocessor-based design, it offers auto-synchronization and auto- sizing capabilities. The monitor offers

15pre-programmed settings that are listed in the following table.

These preset modes cover most of the common video modes supported by popular graphics adapters. However, each adapter’s implementation of these video modes may vary slightly in timing. If it is necessary to make minor display adjustments (horizontal and vertical position and horizontal position), refer to the On-Screen Display section of this manual for instructions.

18

Doc# 27-0001UM Issued 7/99 Rev. 1.2

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Command NS OLE Regulatory FCC InformationContents Shipment Contents System RequirementsProduct Description Precautions Starting PointTools Required Install Rails Install the Slides in the Cabinet FrameSlide Removal Install Rails Install Console Install the Command Console in the SlidesTest Installation and Make Adjustments Final Adjustments of the Command Console Setup Setting UP the Monitor Keyboard and MouseClosing Console Closing Down the MonitorOperation Monitor Adjustments ON-SCREEN DisplayMenu Descriptions Size Auto Calibration Program LED Indicator Timing Guide ReferenceIf using Macintosh, need Mac adapter Troubleshooting Troubleshooting Specifications Appendix PIN AssignmentSupport Further HelpReplacing Parts Providing FeedbackCompliance Y2K ComplianceDrawings Drawings Install Hardware Command ConsoleDoc# 27-0001UM Issued 7/99 Rev Doc# 27-0001UM Issued 7/99 Rev Microsystems, Inc
Top Page Image Contents