Z Microsystems 14 manual Install Rails

Page 8

Install Rails

Go back on the rear of the cabinet frame, and fully tighten the three Phillips screws ((W) see page 30 - Install hardware) holding the slide extension rail to the cabinet frame.

Make sure you hold the slide mounts hard against the rack rail.

Doc# 27-0001UM Issued 7/99 Rev. 1.2

Image 8

Contents Command NS OLE Regulatory FCC InformationContents Shipment Contents System RequirementsProduct Description Tools Required PrecautionsStarting Point Slide Removal Install RailsInstall the Slides in the Cabinet Frame Install Rails Test Installation and Make Adjustments Install ConsoleInstall the Command Console in the Slides Final Adjustments of the Command Console Setup Setting UP the Monitor Keyboard and MouseClosing Console Closing Down the MonitorOperation Monitor Adjustments ON-SCREEN DisplayMenu Descriptions Size Auto Calibration Program LED Indicator Timing Guide ReferenceIf using Macintosh, need Mac adapter Troubleshooting Troubleshooting Specifications Appendix PIN AssignmentSupport Further HelpReplacing Parts Providing FeedbackCompliance Y2K ComplianceDrawings Drawings Install Hardware Command ConsoleDoc# 27-0001UM Issued 7/99 Rev Doc# 27-0001UM Issued 7/99 Rev Microsystems, Inc