Z Microsystems 14 manual Starting Point, Tools Required, Precautions

Page 6

Starting Point

TOOLS REQUIRED

Required Tools and Equipment

• Flathead screwdriver with about 10" shaft.

• Phillips screwdriver with about 10" shaft.

• Computer Setup Diskette

DANGER: To avoid shock hazard:

•Do not remove the covers around the Command Console.

•Do not connect or disconnect the Command Console during an electrical storm.

•The power cord plug must be connected to a properly wired and grounded power outlet.

•Any equipment to which the Command Console will be attached must also be connected to properly wired and grounded power outlets.

PRECAUTIONS

NOTE: For the fastest and easiest installation of the Command Console, follow these steps in the sequence they are presented.

In preparation to install the Com- mand Console, take the following precautionary steps:

Turn off the electrical power to your computer.

Verify the Command Console power switch is off. If the Console is off, the light will not be illuminated.

6

Doc# 27-0001UM Issued 7/99 Rev. 1.2

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Command NS OLE Regulatory FCC InformationContents Shipment Contents System RequirementsProduct Description Precautions Starting PointTools Required Install Rails Install the Slides in the Cabinet FrameSlide Removal Install Rails Install Console Install the Command Console in the SlidesTest Installation and Make Adjustments Final Adjustments of the Command Console Setup Setting UP the Monitor Keyboard and MouseClosing Console Closing Down the MonitorOperation Monitor Adjustments ON-SCREEN DisplayMenu Descriptions Size Auto Calibration Program LED Indicator Timing Guide ReferenceIf using Macintosh, need Mac adapter Troubleshooting Troubleshooting Specifications Appendix PIN AssignmentSupport Further HelpReplacing Parts Providing FeedbackCompliance Y2K ComplianceDrawings Drawings Install Hardware Command ConsoleDoc# 27-0001UM Issued 7/99 Rev Doc# 27-0001UM Issued 7/99 Rev Microsystems, Inc
Top Page Image Contents