Z Microsystems 14 manual If using Macintosh, need Mac adapter

Page 19

Reference

TIMING GUIDE

The monitor is not limited to these preset factory-timing modes. In fact, because the monitor is multi-scan- ning, it can accept any signal within its frequency range of 31.25KHz - 60.24KHz horizontal and 56Hz - 75Hz vertical.

If it is desired to use one of the preset timing modes, refer to the video card manufacturer’s installation guide for instructions on how to make these changes. The video card controls the refresh rate. Most video cards provide software utility or hardware DIP switches that allow to change the frequency used for each resolution.

*If using Macintosh, need Mac adapter.

19

Doc# 27-0001UM Issued 7/99 Rev. 1.2

Image 19

Contents Command NS OLE FCC Information RegulatoryContents System Requirements Shipment ContentsProduct Description Starting Point PrecautionsTools Required Install the Slides in the Cabinet Frame Install RailsSlide Removal Install Rails Install the Command Console in the Slides Install ConsoleTest Installation and Make Adjustments Final Adjustments of the Command Console Setting UP the Monitor Keyboard and Mouse SetupClosing Down the Monitor Closing ConsoleOperation ON-SCREEN Display Monitor AdjustmentsMenu Descriptions Size Auto Calibration Program Reference LED Indicator Timing GuideIf using Macintosh, need Mac adapter Troubleshooting Troubleshooting Specifications PIN Assignment AppendixFurther Help SupportProviding Feedback Replacing PartsY2K Compliance ComplianceDrawings Drawings Command Console Install HardwareDoc# 27-0001UM Issued 7/99 Rev Doc# 27-0001UM Issued 7/99 Rev Microsystems, Inc