Reverb Time
The Reverb Time section includes these 4 parameters:
CONVOLUTION START: Range: 0 TO 1 second; Default: 0 seconds
The Convolution Start control determines the starting point of the convolution process. It enables you to remove unwanted
CONVOLUTION LENGTH: Range: 0 seconds to 6 seconds; Default: Full
This control sets the length of the process filter. By default it is set to Full, which means that the
The Reverb Time Fader controls the Reverb Time Ratio. The resulting reverb time will be the original RT60 multiplied by the ratio.
RT60: (Reverb Time, 60dB) is defined as the time it takes the sound pressure level of a sound to drop by 60dB in gain once the source has been shut off. It is actually a slope factor. RT60 is a term that is commonly used in building construction and architecture to describe a room’s acoustic properties.
This field shows the reverb’s current RT60. It is the original RT60 multiplied by the Reverb Time Ratio. To determine what the original RT60 is, set the Ratio to 1.00. The original RT60 is calculated by analysis of the loaded IR.
Waves