Waves IR-1, IR-L, IR-360 manual This control is only available in the Efficient components

Page 32

In natural IRs, there is no distinct delineation between ER and TR; the definition of where the best ER/TR-X crossover point is subjective. The user is allowed to modify the automatic decision of the plug-in by using the ER/TR-X control, in milliseconds, relative to the automatic crossover point.

In IRs where the direct signal is not found, the Direct Gain and Predelay become disabled.

If the direct signal has already been removed by the user before importing an IR, or if the source of the IR is not acoustically natural, and the direct path is not a part of it, then the plug-in may detect the first early-reflection as direct.

In that case, the user should make sure that the Direct On/Off button is On. In some cases, if the IR is too short or if its behavior is not acoustically natural, the plug-in may fail to detect the Direct, ER, or Tail as separate parts.

This is typical of small rooms or spaces with a reflective floor. The direct signal and the ER cannot be separated, theoretically, since the first ER arrives before the direct path response terminates. They appear as mixed in the IR. In such cases the plug-in presents the best separation, possible, but the direct would appear to include some reflections.

CROSSTALK : Range: 0.0 to 100.0; Default 0.0

This control is only available in the "Efficient" components.

This controls how much Crosstalk is allowed between the IR-series’ input channels. When the Crosstalk is 0.0 the process is multi-mono, convolving left to left and right to right.

When Crosstalk is at 100.0, the plug-in will convolve a summed stereo input. The dry signal is not affected, so the reverb will have elements from the left channel in the reverb of the right channel and vice versa.

Waves IR-1 software guide page 32 of 40

Page 31 Page 33
Image 32
Page 31 Page 33
Contents User’s Guide Table of Contents Waves IR-1 software guide page 3 Introduction Synthetic Digital ReverberationSampled-Acoustics Convolution Reverberation Perfect HybridImpulse Responses IR LibraryPage Sampled Acoustics Virtual Acoustics Devices and SyntheticImport Impulse Response from File… Import Sweep Response from File…Tips for Sampling an Acoustic Space SET-UP Page Channel Configuration # of Convolutions About the IR-360Waves IR-1 software guide page 13 Waves IR-1 software guide page 14 Waves IR-1 software guide page 15 About the IR-L Reverb Time Latency Offline Calculation indicator IR-1AND IR-360 Controls and Displays Reverb Time Reverb Control Parameters Wet Properties Direct Signal Reverb Tail Latency Reverb Envelope Offline Calculation Indicator More about Reverb Damping Reverb EQ High Shelf Filter This control is only available in the Efficient components IR-360 Controls Toolbar WaveSystem ControlsLoading Impulse Responses Saving Importing Impulse ResponsesIR Info and Properties Page System Requirements CPU Mode Switch IR-1 Htdm
Top Page Image Contents