9.0 Error Messages
1. | 0¯ ¯ ¯ ¯ ¯ | Zero point is over the setting range |
2. | 0_ _ _ _ _ | Zero is below the setting range |
3. | AD¯ ¯ ¯¯ | ADC is over max. range; |
4. | AD _ _ _ _ | ADC is below min. range; |
5. | EEP.ER | There is an error in the EEPROM |
6. | CAL.ER | There is an error in calibration |
7. |
| The capacity will be displayed |
8. | LO.BAT | The battery voltage or input power is below 5.6V. |
9.FULL The capacity has been exceeded by the person on the scale.
10.0WARNING
∙Do not dismantle the weighing machine without following the necessary instructions.
∙Do not jump while standing on the platform. This may damage the sensor inside.
∙Do not move the weighing machine violently and abruptly. It is recommended to move and put down the weighing machine gently.
∙It is suggested to wipe the stains with soft cloth soaked with detergent and to wipe later with soft cloth too. Do not use organic solutions and boiled water to wipe the stains. Do not use water for cleaning.
∙Keep the weighing machine in a dry and clean environment. Do not expose it outdoor or use it in locations near fire, under direct sunshine or with high temperature.
∙When lifting the height meter, it is suggested to pull it straight along the pipe without using excessive force.
© Adam Equipment Company 2012 | Page 15 | Rev C5, January 2012 |