3M 800af manual Operation

Operation (Continued)

Figure 3-7

Place a product filled box 55 to 65 mm [2-1/4 to

2-1/2 inches] into the exit end of the machine with the top flaps folded as shown.

Crank the upper head down until is just contacts the top of the box.

Crank the side drive belts in until the belts firmly grip the box.

Figure 3-8

Set Kicker cam relative to length of box being sealed. Measure the distance "X" as shown and set the cam to the same dimension measured on the box. (This dimension provides a good starting point for setting the kicker cam.)

Note: 5 mm hex key wrench is supplied with machine and should be kept in wrench holder on side of upper frame. See Figure 3-1.

Figure 3-7 – Box Size Set-Up

Figure 3-8 – Box Size Set-Up

20