3M 800af manual Important Safeguards, Knife Warning Label

Important Safeguards

This safety alert symbol identifies important messages in this manual.

READ AND UNDERSTAND THEM BEFORE INSTALLING OR OPERATING THIS EQUIPMENT.

Important –In the event the following safety labels are damaged or destroyed, they must be replaced to ensure operator safety. A label kit, part number 78-8113-6881-6 is available as a stock item or individual labels can be ordered. See Parts Illustration/List, Section I, pages 86 & 87.

The "Warning – Hazardous Voltage"label, shown in Figure 1-2, is attached to the cover of the electrical control box on the lower right side of the machine frame. The label warns service personnel to unplug the power supply before attempting any service work on the case sealer.

The "Warning – Sharp Knife"label (A), shown in Figure 1-1, is attached to both sides of the upper frame at the location of the cut-off knife on the upper taping heads. The "Warning – Sharp Knife"label

(B), shown in Figure 1-1, is attached to the orange cut-off knife guard on both taping heads. The labels warn operators and service personnel of the very sharp knife used to cut the tape at the end of the tape application.

Figure 1-1 – Knife Warning Label

Figure 1-2 – Electrical Warning Label

The "Warning – Keep Hands Away From Moving Belts" labels, shown in Figure 1-3, are located on the infeed end of the machine bed on each side. The labels warn operators to keep hands away from this area when drive belts are running.

Figure 1-3 – Box Drive Belt Warning Label

3