Introduction and Installation
6 Remove the sheet covering the connector. Next, after | Connector screw | |
installing the terminal cover in the bottom case, attach | ||
| ||
the connector by tightening the connector screw. |
| |
Next, align the lower portion of the bottom case with |
| |
the lower portion of the front case and press on the |
| |
panel area just above the screen until the tabs lock in |
| |
place. |
|
+ Screwdriver |
• Check that there are no scraps from the board or other debris in the connector before installing it.
■Remove the front case from the bottom case
While pushing the tabs at the top of the front case, pull the top of the front case forward to disengage the front tabs one by one, and then pull the top of front case forward to remove it.
Bottom case
Front case
Remove the connector screw, and then remove the connector.
Do not pull the wire when removing the connector.
13