Introduction and Installation
Note:
•To open the case again, push the bottom of the front case, then release from the
rear case.
To attach the power cable
Sub Monitor station | DC terminal |
Button
Button
Terminal 
Terminalconnector connector
•While pressing on the button hard with a pointed object such as a screwdriver, insert the power cable into the terminal connector.
•To disconnect the power cable, press on the button hard while pulling out.
•To attach an optional power cable, cut off about 12 mm (1/2″) of the cable cover
(
), then push in firmly until the end of the cable is securely inserted into the power connection terminal (
).
Power cable cross section
Correct Incorrect
To attach the wires
•Strip off of the wire cover so that about 9 mm (3/8″) of the wire is exposed.
•While pressing on the button with a pointed object such as a screwdriver, insert the wire into the terminal connector.
•To disconnect a wire, press on the button while pulling out.
16