Panasonic WV-CM1780, WV-CM1480 Connection with the System Controller, Setting the Termination

■Connection with the System Controller

If the optional 6-conductor cable assembly is used, simply plug one end of the cable into the DATA port of the Monitor and the other end into the DATA port on the System Controller.

If you use cables assembled from locally procured materials, it is important that only high quality, data grade cable, suitable for RS-485 communication (shielded 4-wire twisted pair cable), BELDEN 9406 or equivalent, is used.

Lower grade cable will result in unstable operation of the system.

		DATA		DATA				RA
								RB
		ON OFF		ON OFF
TERMINATION			TERMINATION					TA
	To the				G TA TB	RA RB G
					N		N	TB
	System Controller				D		D

System Controller WV-CU360

PROGRAM

●Setting the Termination

Set the Termination Selector located on the rear of the monitor according to your requirements.

ON: Data is terminated.

OFF: Data is sent to other equipment.

■Connection between two or more color monitors and a device compat-

ible with Panasonic Security Data mode

In case of connecting multiple devices compatible with the Panasonic Security Data mode, connect the unit in a daisy-chain configuration as shown below. The allowable connecting devices are up to 16 in a system. The maximum allowable cable length of the system is approximately 500 m (1 650 ft).

			Termination: OFF					Termination: OFF
FOCUS		AUDIO	B VIDEO	A	FOCUS	AUDIO		B VIDEO	A
	B		IN	IN			A	IN	IN
		A				B
DATA	STANDBY IN	IN	S-VIDEO		DATA	STANDBY IN	IN	S-VIDEO
	ON					ON

STANDBY

STANDBY

OFF

OFF

G

G

ON OFF

OUT

OUT

IN

OUT

OUT

AC IN

ON OFF

OUT

OUT

IN

OUT

OUT

AC IN

TERMINATION

TERMINATION

Modular
cable
(Supplied:
WV-CU360)	Termination: ON
	System Controller WV-CU 360
	PROGRAM

System Controller compatible with PS•Data mode

Termination: ON

DATA

Device compatible with PS•Data mode

To the Data port (optional)

■Connection to the Standby On/Off Terminal

Connecting an external device to the STANDBY ON/OFF Terminal on the rear of the monitor enables control of the monitor dis- play by input from that device, both in normal and standby display mode.

Shown below is an example of how to use this function.

STANDBY

ON

STANDBY

OFF

G

Alarm Output

Alarm Reset Output

Hi-Z

VL 0.2 V

VH 5 V

VL 0.2 V

•STANDBY ON input Pulse +5 V DC

•STANDBY OFF input

Non-voltage contact or open collector output

Note: To set up this function, refer to STANDBY ON in the Display Setting menu.

8