Troubleshooting (cont.)
Symptom | Checkpoint | ||
|
|
| |
|
| • Check if the computer and the projector are located too far | |
|
| apart, or if some object is obstructing the radio waves. | |
|
| • Check that the IP address and the subnet mask are set | |
|
| correctly. | |
|
| • Is TCP/IP installed in the computer? | |
|
| • Does the WEP setting match with the projector? | |
|
| Communication is not possible if the WEP function is set | |
|
| when using a wireless card other than the optional card or | |
|
| when using an access point. In these cases turn off the WEP | |
|
| function. | |
The | projector | • In [Infrastructure] mode, set the same [SSID] for the projector | |
cannot be located | and the computer as that of the access point used. The | ||
on the connection | [SSID] uses alphanumeric characters (case sensitive). In | ||
list of | Wireless | addition, check that the computer control function that allows | |
Manager ME. | communication with access points is disabled. | ||
|
| • In [802.11 AdHoc (Peer to Peer)] mode, set the same SSID | |
|
| for the projector and the computer. The SSID is case | |
|
| sensitive. | |
|
| • Is a network device other than the wireless card enabled? | |
|
| Check the Windows Device Manager. | |
|
| • Is | |
|
| communicating with the projector. | |
|
| • Are you running a security program that contains a personal | |
|
| firewall function? Before communicating data using the | |
|
| projector, either close the software or set up an exemption. | |
|
|
| |
The | Wireless | • | |
Manager ME color | |||
display is strange | [Properties]. Then, open the [Settings] tab of the [Display | ||
Properties] window and set [Color quality] to [Medium (16 bit)] | |||
and characters are | |||
or higher. | |||
difficult to read. | |||
| |||
|
|
|
56