Outlaw Audio ECS-10 owner manual

Owner’s Manual

Wiring Diagrams

Diagram 2: Connecting to a System without a Subwoofer Preamp Output, but with Standard Left/Right Preamp Outputs

					INPUT	INPUT	INPUT
								CAUTION OFRISK	PAS OUVRIR
									ELECTRIQUE/NECHOC
					FRONT RIGHT	FRONT LEFT	CENTER	SHOCK
								OPEN
								ELECTRIC NOT
								DO
					OUTPUT	OUTPUT	OUTPUT		AVIS: RISQUE DE
		SUBWOOFER			+	+	+
					-	-	-
		VOLUME
				MIN	MAX
ECS-10	AUTO ON/OFF		INACTIVE		ACTIVE
					80 Hz
		LOW-PASS
		CROSSOVER					Amplifier
				120 Hz	40 Hz
POWER		INTERNAL			SUBWOOFER
			X-OVER		DIRECT
ON		PHASE			180°
				R	L
		OUTPUT
OFF		INPUT
	SPEAKER LEVEL INPUT				LFE
+	R	-	-	L	+
120V~
60HZ
8A
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
AVIS: RISQUE DE CHOC ÉLECTRIQUE. NE PAS OUVRIR
ECS-10

Receiver or Processor

INPUT

SURROUND RIGHT

OUTPUT

+

-

WARNING:

HAZARDOUS ENERGY. MAKE PROPE

CONNECTIONS: SEE OWNER'S MANU

5.Plug the ECS-10’s power cord into an un-switched AC outlet.

CAUTION: Due to the power requirements of the ECS-10, it must not be connected to the accessory outlets on a receiver or processor. If a power-strip or surge protector is used, make certain that it is rated to accommodate the ECS-10’s power requirements.

6.Reconnect your processor or receiver to the AC power source.

7.Proceed to the “Setting the ECS-10’s Controls” section to learn about the ECS-10’s controls and how they operate.

Connecting to a System without a Subwoofer Preamp Output, but with Standard Left/Right Preamp Outputs

If your system does not have a dedicated subwoofer preamp output, but has left/right preamp outputs, you can use these jacks to connect your receiver or processor to the subwoofer amplifier. See Diagram 2 below.

To connect an ECS-10 Subwoofer using standard Left/Right preamp outputs:

1.Turn off all system components and unplug the processor or receiver and the ECS-10 from their AC power source.

2.Locate the “Left/Right preamp outputs” on the rear panel of your receiver or processor.

Some audio products that do not offer digital surround processing will have these types of jacks. If your receiver or processor does not have this type of output you will need to follow the “Connecting to a system with no pre-amp outputs” instructions that follow this section.

3.Connect one end of the audio interconnects to the left and right preamp outputs on the receiver or processor.

4.Locate the connections labeled “INPUT” on the rear panel of the ECS-10 and connect the other end of the interconnects to these jacks.

6

Outlaw Audio