Starting Up/Shutting Down
Getting Started
•If there is no disk set in the
zWhen the CPU temperature rises, the computer may not power on to prevent the CPU from overheating. Should this happen, allow the computer to cool down then switch the power on again.
If the computer still does not power on, contact your technical support office.
If the screen on the left is displayed immediately after
you turn on the power...
A password has been set to ensure the computer's security.
Enter your password*1 and press the Enter key.
zWhen the correct password is input, the computer will start.
zWhen three incorrect password attempts or nothing is input for one minute, the com- puter will power off.
*1 Supervisor Password or User Password set in the Setup Utility (not the Windows password).
Shutting Down (power off your computer)
1 Save necessary data and close each application.
2 Display the shutdown screen.
Click [start] - [Turn Off Computer].
3 Click [Turn Off].
Your computer will power off automatically.
zRestarting your computer (without shutting down): click [Restart].
To shut down using the keyboard:
APress the 
key, the U key, and select [Turn Off] with the Î Í Ï Ð key.
BPress the Enter key.
CAUTION
zDo not do the following during the shutdown/restart procedure.
•Connecting or disconnecting the AC adaptor.
•Touching the power switch.
•Performing any keyboard, touch pad or external mouse operations.
•Closing the display.
•Sliding the drive power/open switch.
NOTE 
zWhen the DC plug is not connected to the computer, disconnect the AC cord from your AC wall outlet. About 1.5 W of power is consumed simply by having the AC adaptor plugged into an electrical outlet.
zNote that the computer consumes electricity even when the computer power is off. If the battery pack is fully charged, the battery will fully discharge in Approx. 3 weeks.
When you leave the computer or interrupt your work...
If you use the “Standby” or “Hibernation” function, then when you turn on the power next time, the application software and files you were using before will be displayed, and you can restart the same operations. (Î “Standby/Hibernation Functions” in onscreen Reference Manual)
24