Setup Utility
The Setup Utility sets the computer's
[Information], [Main], [Advanced], [Security], [Boot], [Exit]
Running the Setup Utility
1 Turn on or restart the computer.
2 Press the F2 key while [Panasonic] boot screen is displayed
soon after the computer begins the startup procedure.
When the password is set, the screen shown at left will be displayed. Enter your password, and press the Enter key.
When inputting the Supervisor Password
zYou can register all items of the Setup Utility. When inputting the User Password
zOn the [Advanced] and the [Boot] menu:
•You can view the settings, but cannot change it.
zOn the [Security] menu:
•The following will not be displayed: [Clear registered SD card], [Set Supervisor Password] and [Hard Disk Lock].
•The following will be displayed, but cannot be set:
•The User Password can be changed only when [User Password Pro- tection] has been set to [No Protection]. The User Password cannot be deleted.
zOn the [Exit] menu:
•[Get Default Values] option will not be displayed.
zThe F9 key does not work.
NOTE
zCannot display the Setup Utility screen in simultaneous display.
By pressing the Fn+F3 key, display destinations can be changed either exter- nal display or the internal LCD.
zWhen [Password on boot] in the Setup Utility is set to [Disable]:
•When the computer is started up, entering a password is not necessary.
•When the Setup Utility is started up:
The password becomes necessary. This alternative can prevent the contents of the Setup Utility from being changed.
zIf you fail to press the F2 key at the right moment, the Setup Utility will not start up. In this case, let the computer fully boot up, and then perform a shutdown or restart from Windows.
zTo close the Setup Utility: A Press the Esc key.
B Select the exiting method from the [Exit] menu and press the Enter key. C Select [Yes] and then press the Enter key.
Getting Started
29