Panasonic CF-71 manual Internet Explorer, Reinstallation, Power Saving Function in the Sound Chip

Page 41

Technical Information

41

Internet Explorer

Internet Explorer 4.01 places a tremendous load on the system in order to execute the wide variety of functions that it provides. As a result, some unexpected faults may occur.

If any of these faults occurs, try using the software with some Internet Explorer 4.01 functions turned off. (See Internet Explorer Help for more details.)

It takes a long time to reboot or the computer locks up.

Delete the check mark for [Internet Explorer Channel Bar] in [Control Panel] - [Display] - [Web], then press [OK].

A system module error occurs.

Set [ (None)] for [Wallpaper] in [Control Panel] - [Display] - [Background].

Performing the above steps does not solve the problem. Uninstall Internet Explorer 4.0 with the following step.

Select [Microsoft Internet Explorer 4.01] in [Start] - [Settings] - [Control Panel] - [Add/ Remove Programs] - [Install/Uninstall] and press [Add/Remove]. Follow the on-screen instructions.

If a window with the message [Version Conflict] appears during the installa- tion process (network card and application installation), select [Yes].

Proper operation may not be possible if [NO] is selected.

Reinstallation

When Windows is started up while pressing F8 , the [Microsoft Windows 95 Startup Menu] is displayed. After reinstalling Windows, [Previous version of MS-DOS] also appears in this menu, however, do not select this item as MS-DOS is not installed.

Power Saving Function in the Sound Chip

The sound chip has its own power saving function. You can enable this function in the [OPL3-SAx power management] tab (select [Start] - [Settings] - [Control Panel] - [Power] - [OPL3-SAx power management]).

In [Non Power Save mode], the power saving function is disabled.

(When a ZV card is used, set [Non Power Save mode] to enable sound to be normally produced. This is the default setting.)

In [Minimum level of power save], the power saving function is enabled. You may en- counter problems, such as no sound from music CDs.

Do not select [Intermediate level of power save] or [Maximum level of power save] be- cause noise is likely.

Image 41
Contents Reference Manual CF-71 Series ContentsKey Functions Popup Window Key CombinationsLED Indicators Drawing Characters or Figures Panasonic Hand Writing Touch PadDetermine the position to begin drawing To nextSelect Save As or Save from File Close the Hand Writing modePanasonic Hand Writing Touch Pad Shutting Down Using the Suspend or Hibernation Function Setting the Suspend or Hibernation FunctionSuspend/Hibernation Functions Starting Up Your Computer QuicklyResuming Operation Push the sleep switch or Slide the power switchSuspend/Hibernation Functions Precautions for Using the Suspend or Hibernation Function Setting the user password enabling, changing, disabling When the User Password is setSecurity Measures Situation Function to use ReferenceRe-enter your password at the Enter User Password Again To disable your passwordWhen the coffee break password is set Security MeasuresTo disable the Coffee break Password Setting the Coffee break Password enabling or disablingProcedure Preventing theft of damage to data using a floppy diskRun the Setup Utility Using When the supervisor password is setEnabling, changing, disabling Setting the Supervisor PasswordTo disable your supervisor password Things to Remember Conserving PowerComputing On the Road Hibernation with Using Setting Power ManagementHow to set Advanced and the suspend/hibernation timeout Computing On the RoadPower Management settings Battery Status Battery PowerUse the Battery Indicator to Check on the Battery Status Fn + F9When the Remaining Battery Charge Becomes Low Battery PowerSave your data and power off your computer If the suspend or hibernation function is setRemove the battery pack Replacing the Battery PackOpen the display Open the coverConnector Tab Label-side up Flat Cable Connect the battery packWhen closing the cover Close the coverInstalling/Removing a Multimedia Pocket Device Using a Multimedia Pocket DeviceUsing the Floppy Disk Drive as an External Drive Using a Multimedia Pocket DeviceParallel Port FDD CableInstalling/Removing the PC Card Using PC CardsInstalling a PC Card PC CardUninstalling Using PC CardInstalling only if the ZV card does not operate properly PC Card Utility ProgramRAM Module Installing/Removing the RAM ModuleAdding Memory Port Replicator Using a Printer Connect the external display to your computer Using an External DisplayExternal Display Port + F3Run the Setup Utility Using Enter Using USB DevicesUSB Port Using USB DevicesInfrared Data Communications Setting for Infrared Data CommunicationsPreparations for Infrared Data Communications Data CommunicationsHard Disk Drive Installing/Removing the hard diskRemoving/Installing the hard disk Ribs ConnectorHard disk Drive Running the Setup Utility Setup UtilityClosing the Program Main ScreenParameters Setup UtilitySystem Setup Power Management Settings Power ManagementWSS Codec I/O Supervisor Setup IRQ Network Technical InformationHard Disk Technical InformationSome software will not run normally Non-recognition from other operating systemsPower Saving Function in the Sound Chip ReinstallationIt takes a long time to reboot or the computer locks up System module error occursCode Description List of Error CodesSaving information to a file DMI ViewerRunning DMI Viewer Starting Up Dealing With ProblemsBattery Indicator Disk Operations Dealing With ProblemsDisplay Network Character InputApplication Software Connecting Peripherals Disclaimer Trademarks Copyright