Panasonic CF-71 manual Connecting Peripherals

Dealing With Problems

47

Connecting Peripherals

Your peripheral does not	You need to use drivers conforming to Windows 95 Version 4.00.950C (OSR-2.5).
work (An error occurs	Some earlier drivers will no longer work.
while installing the driver)	For more information, please ask the manufacturer of the driver in question.
Unable to print		Check the computer-printer connection.
		Make sure the printer is on.
		Make sure the printer is in the online state.
		Make sure paper is in the printer tray and there is no paper jam.
		Has the Setup Utility been used to set [Parallel Port (Address)] to [Automatic (PnP)],
		[378] or [3BC]?
The cursor does not		The Coffee break Password may be set; check if		is displayed. If this is the
move from mouse opera-
		case, input the Coffee break Password.
tions
		Check your mouse connection, then reboot the computer from the keyboard.
		From the keyboard, you may choose to press down on			, then select [Shut
		Down].
The device connected to		Check the connection.
the serial port does not		Confirm that the device driver for the serial port works. Please refer to the refer-
work		ence manual of the device.
		Confirm that two mouse devices are not connected, one through the external key-
		board/mouse port and the other through the serial port.
		Try setting [Touch Pad] to disable in the Setup Utility.
		Has the Setup Utility been used to set [Serial Port] to [Automatic (PnP)] or [3F8]?
E x t e r n a l m o u s e o r		Try setting [Touch Pad] to disable in the Setup Utility.
trackball connected to		In some circumstances, if a PS/2 external mouse with a serial interface conver-
the external keyboard/		sion function is connected to the port, it may not operate normally. Try connecting
mouse port does not		it to the serial port.
work		If a switch is made to the Hand Written mode in Panasonic Hand Writing, any
		external mouse or trackball connecting to the external keyboard/mouse port will
		not operate. Reconnect the device after quitting the Hand Written mode. If the
		device still does not work, try restarting the computer.
A PC Card does not work		Make sure the card is properly inserted.
		Confirm that the card conforms to the PC Card Standard.
		Note that after a driver is installed, the computer must be rebooted.
		Check that the proper port settings have been made.
		Read the PC Card’s manual. Or, you may need to call the manufacturer of the PC
		Card.
		If the ZV card does not operate properly, install PhoenixCard ManagerTM for Win-
		dows® 95. (	page 24)
You do not know the		page 25
available RAM module
The RAM module has not		Make sure the RAM module has been properly inserted.
been recognized		Use the RAM module that support the recommended specifications.
The address map for	Check the address map by going to [View Resources] in [Start] - [Settings] - [Control
IRQ, I/O port address,	Panel] - [System] - [Device Manager] - [Computer] - [Properties].
etc. is unclear
A USB device does not		Make sure a driver is installed.
work		Contact the manufacturer of the product.