Stand-by operation | Sennheiser EM 3532-U manual

19 Stand-by operation

The EM 3532 receiver can be set to stand-by operation. During stand-by operation, information from the RF section is no longer processed and the AF section is muted (MUTE). All other menus

–except for “REMOTE” and “STANDBY” – are locked. If you try to select any other menu, “Loc” appears on the display.

Press the

/ buttons to select the “STANDBY” menu. The current setting – i.e. “On” or

“OFF” – is indicated on the display.

Then press the SET button. The “STANDBY” display on the display panel begins to flash.

You can now select your desired setting:

Press the

button to switch on the stand-by operation, “On” appears on the display:

Press the button to switch off the stand-by operation, “OFF” appears on the display:

Your setting has to be stored before it becomes effective. To store a setting, press the SET button until “Sto” briefly appears on the display, indicating that your setting has been stored. The display then switches back to the standard display.

If the receiver is set to stand-by operation, the “STANDBY” display on the display panel is lit up.

You can discontinue the programming of this menu at any time by briefly (!) pressing the SET button. The previous setting is then kept. If you do not press any of the three programming buttons for more than 30 seconds, the setting mode is automatically left and the previous setting is also kept.