23 Replacing a fuse
Disconnect the receiver completely from the mains! To do so, pull out the mains connector on the receiver. You can then remove the fuse holder with the inserted fuse. Replace the fuse by a new fuse with the same rating and switch on the receiver again. Make sure that you have inserted the fuse holder the correct way round! The set voltage is shown at the top of the fuse holder.
A faulty fuse should always be regarded as a warning. In most cases, the cause is harmless – a short voltage surge or some similar cause has triggered the protective mechanism. When the fuse has been replaced, the receiver works again.
If the replacement fuse also blows, please consult a specialist who can discover the cause. We recommend you to contact your Sennheiser distributor or to send the receiver, with a precise description of the trouble, to a Sennheiser service department in your area. You can find the address of your nearest service department in the enclosed Service card or on the Internet at “http://www.sennheiser.com”.
65