Panasonic PT-D5500EL manual Side-mounted connection terminals

Side-mounted connection terminals

		R/PR	G/Y	B/PB	SYNC/HD	VD
VIDEO IN	S-VIDEO IN			RGB 1 IN			RGB 2 IN	DVI-D IN	LAN
	REMOTE 1		REMOTE 2 IN		IN	SERIAL	OUT
	IN	OUT

VIDEO IN terminal (page 19)

An input terminal for video signals. (BNC)

S-VIDEO IN terminal (page 19)

An input terminal for S-video signals (MIN4-pin DIN).

This terminal complies with S1 signals and automatically toggles between 16:9 and 4:3 according to the size of input signals.

RGB (YPBPR)1 input terminal (pages 19, 20)

A terminal to input RGB or YPBPR signals (BNC).

RGB (YPBPR)2 input terminal (page 20)

A terminal to input RGB or YPBPR signals (D-SUB 15-pin female).

DVI-D IN terminal (page 20)

DVI-D signals are applied to this terminal. (24-pin DVI connector)

LAN terminal (page 37)

This terminal is used to control the projector from the PC. (10Base-T/100Base-TX compliant)

REMOTE1 lN/OUT terminal (page 16)

When two or more main units are used in the system, they can be connected and controlled with a wired remote control cable (M3 jack).

REMOTE2 IN terminal

The user can remotely control the main unit by using an external control circuit to this terminal (D-SUB 9-pin female).

SERIAL IN terminal (pages 20, 38)

Use the RS232C serial terminal as an alternative interface for controlling the projector from your PC (D-SUB 9-pin female).

SERIAL OUT terminal (page 20, 38)

The signal applied to the serial input port appears at this terminal (D-SUB 9-pin male).

ENGLISH

13