Panasonic PT-D5500EL manual Using the Remote 2 terminal, Pin assignments and control

Using the REMOTE 2 terminal

Using the REMOTE 2 terminal provided on the side of the main unit, it is possible to operate the projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot be received.

Example of a control panel layout

Projector set up in a meeting room

Pin assignments and control

Be sure to short-circuit Pins and when controlling.

D-Sub 9-pin (female) external appearance

Remote terminal	External control
Remote terminal/External control
STANDBY	ON
LAMP
RGB1	VIDEO
RGB2	S-VIDEO

DVI

Control panel located in a different room

		Names of terminals			Open (H)	Short (L)
1			GND			GND
2			POWER	OFF	ON
	3		RGB1		Other	RGB1
4			RGB2		Other	RGB2
5			VIDEO		Other	VIDEO
6			S-VIDEO		Other	S-VIDEO
7			DVI		Other	DVI
8			SHUTTER		OFF	ON
9			RST / SET	Controlled by remote control		Controlled by external contact

Note • The following buttons on the remote control and the operation area of the projector can no longer

be operated when pins and are shorted: POWER button, RGB1 button, RGB2 button, VIDEO button, S-VIDEO button, DVI button and SHUTTER button.

Neither will it be possible to use the RS232C commands or Web browser controls corresponding to these functions.

40