Adjusting the position
When the input signal is from a PC, first select “AUTO SETUP” and then press the ENTER button to initiate automatic positioning.
If the optimum setting is not obtained when “AUTO SETUP” is carried out, adjust by the following procedure.
Press the F or G button to select an item, and then press the I or H button to change the setting.
Horizontal position
To move the picture to the left: I button
To move the picture to the right: H button
Vertical position
To move the picture down: I button
To move the picture up: H button
DOT CLOCK
(PC only)
BWhen YPBPR signals are being input, “CLOCK PHASE” can be adjusted only when
1 125 (1 080)/60i, 1 125
(1 080)/50i, 750 (720)/60p or 750 (720)/50p signals are being input.
ASPECT
Refer to page 30.
AUTO SETUP
(PC only)
NOTE:
BWhen the “ASPECT” is set to “V SCROLL” (page 30), “AUTO SETUP” cannot be performed.
For items with bar scales, press the ENTER button or the I or H button to display the adjustment screen, and then Press the I or H button to make the adjustment.
When an
POSITION |
|
H - POSITION | 0 |
|
|
V - POSITION | 0 |
ASPECT | 16:9 |
SELECT ENTER | ESC |
When a YPBPR signal is being input
POSITION |
|
H - POSITION | 0 |
|
|
V - POSITION | 0 |
|
|
CLOCK PHASE | 0 |
|
|
ASPECT | 4:3 |
SELECT ENTER | ESC |
When a PC signal is being input
POSITION |
|
H - POSITION | 0 |
|
|
V - POSITION | 0 |
|
|
DOT CLOCK | 0 |
|
|
CLOCK PHASE | 0 |
|
|
ASPECT | 4:3 |
AUTO SETUP |
|
SELECT ENTER | ESC |
Periodic striped pattern interference (noise) may occur when a striped pattern such as the one below is projected. If this happens, press the
Ior H button to adjust so that any such noise is minimised.
CLOCK PHASE
(PC/YPBPR only)
Adjust the “DOT CLOCK” setting first before carrying out this adjustment. Press the I or H button to adjust so that the noise level is least noticeable.
NOTE:
BIf signals with a dot clock frequency of 100 MHz or higher are being input, interference may not be completely eliminated when the “DOT CLOCK” and “CLOCK PHASE” adjustments are carried out.
Turning off the picture momentarily (SHUTTER)
The “SHUTTER” function can be used to momentarily turn off the picture |
| |
when the projector is not being used for short periods of time. The projector |
| |
uses less power in “SHUTTER” mode than it does in normal projection |
| |
mode. |
| |
settings | ||
#Select “SHUTTER” from the “MAIN MENU” and then press the | ||
| ||
ENTER button. |
| |
$Press any button on either the projector or remote control unit | and | |
(except the LIGHT button) to return to normal operating mode. | ||
Adjustments | ||
Changing the display language | ||
| ||
|
|
#Select “LANGUAGE” from the “MAIN MENU” and then press the ENTER button.
$Press the F or G button to select a language and then press the
ENTER button.
LANGUAGE | ENGLISH |
| Indicates the language which is |
|
| ||
|
|
|
|
ENGLISH |
|
| currently set |
DEUTSCH |
|
| |
FRANÇAIS |
|
|
|
ESPAÑOL |
|
|
|
ITALIANO |
|
|
|
SELECT ENTER | ESC |
|
|