OPTION2 settings
|
| OPTION2 |
|
|
|
|
| ID |
| ALL | |||
| FRONT/REAR |
| FRONT | |||
| DESK/CEILING |
| DESK | |||
| LAMP POWER |
| HIGH | |||
| RS232C |
|
|
|
|
|
| SYSTEM INFORMATION |
|
|
|
| |
| FAN CONTROL1 |
| NORMAL | |||
| FAN CONTROL2 |
| HORIZ. | |||
| FUNC1 |
|
|
|
|
|
| KEY ASSIGN |
| NORMAL | |||
| AUTO POW. OFF |
| DISABLE | |||
| PASSWORD |
|
|
|
|
|
| SELECT | ADJ |
|
|
| RETRN |
|
|
| ||||
|
|
|
LAMP POWER
The luminance of the projection lamp can be changed depending on user’s needs or the viewing conditions.
HIGH : Set when high brightness is necessary.
LOW : Set when high brightness is not necessary.
Note • When set to “LOW”, it is possible to reduce power consumption, reduce
operating noise and extend lamp service life.
•“LOW” is set automatically when long life lamp units are used.
ID
The projector has an ID number setting function that helps the user to control two or more projectors either simultaneously or separately with a single remote control. The ID number is set to “ALL” by default. Hence the ID number need not be set when only one projector is used.
Note • The ID number can be set to “ALL”, or selected from “1” to “64”.
•If the projectors are given ID numbers, their remote controls must be assigned the same ID numbers, respectively.
•If the ID number of a projector is set to “ALL”, it can be controlled by the remote control or the PC with any ID number.
If multiple projectors are used and some of them have their IDs set to “ALL”, they cannot be controlled separately from the projectors with other ID numbers.
For details on remote control ID setting, see page 15.
FRONT/REAR
“FRONT/REAR” is used to choose the appropriate projection scheme from Front and Rear:
FRONT : Choose this option if pictures are projected from the front of a reflective screen.
REAR : Choose this if pictures are projected from the back of a translucent screen.
RS232C
This sets the communication parameters at the serial terminals.
For details on the serial terminals, refer to “Using the serial terminals” (page 39).
BAUDRATE | : 9 600, 19 200 or 38 400 is |
| selected. |
PARITY | : NONE, EVEN or ODD is |
| selected. |
SYSTEM INFORMATION
The projector’s system information can be viewed.
SYSTEM INFORMATION
ROM VERSION | 1. 00. 00 |
SET RUNTIME | 300h |
LAMP LOW | 100h |
HIGH | 200h |
TOTAL | 300h |
LAMP ON | 20 |
LAMP TYPE | LAD35 |
RETRN
FAN CONTROL1
The fan can be controlled in accordance with the operating conditions.
NORMAL : Standard setting
HIGHLAND : This is selected when using the projector at an altitude of over 1 400 metres.
ENGLISH
DESK/CEILING
DESK/CEILING is used to choose the appropriate projection scheme from Desk and Ceiling:
DESK : Choose this option if the projector is installed on a
CEILING : Choose if the projector is installed on the ceiling using the optional ceiling mount bracket.
35