Panasonic TQBJ0299-3 manual Projector Setup menu, Projector ID, Installation, High Altitude Mode

PROJECTOR SETUP menu

Settings

Remote control

See “Navigating through the menu” on page 15.

See “Main menu and Sub-menu” on page 12.

PROJECTOR ID

The projector has an ID number setting function that helps the user to control multiple projectors either simultaneously or separately with a single remote control. Press I H to cycle through the options.

ALL	Available to control from any ID
	numbered remote control or computer.
1 - 64	Available to control from the same ID
	numbered remote control.

NOTE:

•See “Remote control ID” in the operating instructions booklet that is provided with the projector.

INSTALLATION

When installing the projector, select the projection method according to the projector position. Press I Hto cycle through the options.

FRONT/FLOOR	Setting on a desk/floor and projecting
	from front
FRONT/CEILING	Mounting on the ceiling and projecting
	from front
REAR/FLOOR	Setting on a desk/floor and projecting
	from rear
REAR/CEILING	Mounting on the ceiling and projecting
	from rear

HIGH ALTITUDE MODE

If you use the projector at high elevation, the HIGH ALTITUDE MODE setting needs to be ON to set the fan speed high. Press I H to select the required option.

OFF	The fan speed is low.
ON	The fan speed is high.

NOTE:

•At 1 400 - 2 700 m (4 593 - 8 858 ft) sea level, the setting must be ON.

•The loudness of fan noise depends on the HIGH ALTITUDE MODE setting.

COOLING CONDITION

You can control the fan speed for projecting angle. Press I H to cycle through the options.

VERTICAL UP

SETTING

FLOOR	CEILING
SETTING	SETTING

VERTICAL DOWN

SETTING

NOTE:

•When the projector is angled, COOLING CONDITION setting must be set correctly. Failure to observe this may result in malfunctions, or the life of the lamp or the other components may be shortened.

NOTE:

•See “Projection method” in the operating instructions booklet that is provided with the projector.

ENGLISH - 28