Panasonic PT-L759XU, PT-L759VU manual Setting procedure, Select 1 ...... DESK/FRONT

Setting-up Positions and Changing the Projection Mode

The projection mode used by the Projector can be changed in accordance with the setting-up position. Including ceiling mounting, you may select from four direction types. At the time of shipment from the factory, the Projector is set to the No.1 “DESK/FRONT” projection mode, but this can be changed if required.

The procedure and on-screen display as shown below are based on RGB as the input signal from a personal computer. (See page 17.)

• Setting procedure

1 Press MENU to display the menu.

2 Press or to select “Function”, and then ENTER to display the screen.

P i c t u r e

S y n c h r o n i z a t i o n

F u n c t i o n

L a n g u a g e

I n f o r ma t i o n

: S e l e c t

EN T ER : E n t e r

MENU : E s c a p e

3 Press or to select “Projection Mode”, and then ENTER to display the screen.

	RGB 1 / Y PBPR		RGB 1
	RGB 2 I N / RGB 1	OU T	OU T
	K e y s t o n e	+ 1 0
	P r o j e c t i o n Mo d e		1
	C omp r e s s i o n		x 0 . 6
	On S c r e e n D i s p l a y		ON
	A u t o L amp O f f		Y E S
	R e s e t
	: S e l e c t
EN T ER : E n t e r
MENU : E s c a p e

4 Press or to select projecting mode from 1 to 4.

•Select 1 ..... DESK/FRONT (Factory setting)

•Select 2 ..... DESK/REAR (Right and Left displays in reverse)

•Select 3 ..... CEILING/REAR (Up and Down displays in reverse)

•Select 4 ..... CEILING/FRONT (Up and Down/Right and Left reverse display.)

	P r o j e c t i o n Mo d e	1
	R e s e t
	: S e l e c t
	: A d j u s t
MENU : E s c a p e

Note

•Press MENU to remove the setup screen and menu.

•When reset is selected, adjustment values return to their factory default settings.

Select 1 ...... DESK/FRONT

Select 2 DESK/REAR

(Factory setting)			(Right and Left displays in reverse)
	Select 3	CEILING/REAR		Select 4	CEILING/FRONT

(Up and Down displays in reverse)

(Up and Down/Right and Left reverse display)

Note

• If the lettering on the screen is projected backwards or upside down, it is because the wrong mode has been selected.

22