Panasonic PT-L759VU manual When adjusting the Horizontal Position H Position, Dot Clock, Phase

Adjusting the Image Position, Dot Clock and Phase

Confirm the picture position, Dot Clock, and Phase. If the picture is not correctly positioned within the display area of the screen (the edge of the picture does not appear), adjust the picture position. (This only applies for RGB, YPBPR, DVI-D [PT-L759XU only] input signal.) The items which can be adjusted will vary depending on the type of input signal. The procedure and on-screen display as shown below are based on RGB as the input signal from a personal computer. (See page 17.)

• When adjusting the Horizontal Position (H Position)

1 Press MENU to display the menu.

2 Press or to select “Synchronization”, and then ENTER to display the screen.

P i c t u r e

S y n c h r o n i z a t i o n

F u n c t i o n

L a n g u a g e

I n f o r ma t i o n

: S e l e c t

EN T ER : E n t e r

MENU : E s c a p e

3 Press or to select “H Position”, and then ENTER to display the H Position individual adjustment screen.

•When adjusting the Vertical Position, Dot Clock, and Phase, move the arrow to the item you want to adjust.

	A u t o S e t u p
	H P o s i t i o n	+ 1 0
	V P o s i t i o n	+ 1 0
	D o t C l o c k	+ 1 0
	P h a s e	1 0
	R e s e t
	: S e l e c t
EN T ER : E n t e r
MENU : E s c a p e

4 Press or to adjust the H Position setting.

•The current setting will be displayed on the screen by numerals and a bar.

	H P o s i t i o n	+ 1 0
	R e s e t
	: S e l e c t
	: A d j u s t
MENU : E s c a p e

Note

•Press MENU to remove the setup screen and menu.

•When reset is selected, adjustment values return to their factory default settings.

Depending on the adjustment item, the adjust procedure and adjustment will vary. Please refer to the chart below.

Adjustment item	Button		Adjustment Details	Note
H Position	Press	button.	The image moves to the right.
	Press	button.	The image moves to the left.
V Position	Press	button.	The image moves up.
	Press	button.	The image moves down.
Dot Clock	Adjust the personal computer's dot clock and the projector's dot			RGB,YPBPR only
	clock so that no bit interference (vertical stripes) appears on the			[For UXGA, bit interference (vertical stripes)
	screen.			may still appear even after adjustment.]
	Adjust in order to remove any picture interference or contour			Only RGB signal from a
Phase	blurring which may occur in computer images.
				personal computer

Note

•The last adjustment condition is saved and will not be erased even if the power is turned off.

•The value differs with each input signal.

33