System Configuration Example
Notes on system configuration
•Turn off the power supply of each system component before connecting any of the components.
•Read the instruction manual for each system component before connecting it.
•If the necessary cables for connecting any system components are not supplied with the component or available as an option, you may need to fashion a cable to suit the component concerned.
•If there is a lot of jitter in the video signal input from the video source, the picture on the screen may flicker. In such cases, it will be necessary to connect a TBC (time base corrector).
•The Projector can be connected to video signal sources which out put VIDEO,
•The Projector has
•It may not be possible to connect some types of personal computer.
Example of connection to audio-visual equipment
Diagram numbers correspond with numbers (see page 44.)
DVD player
5 (Audio Cable) |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| (not included) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Connector jacks on left side of Projector
Audio system | 6 (Video Cable) |
| VCR |
5 (Audio Cable) | 5 (Audio Cable) |
Note
•Only one audio signal input system is available for the VIDEO AUDIO IN terminals for
•If an audio system is connected to the AUDIO OUT terminal, muting can be controlled by the remote control which is supplied with the Projector.
•If the video signal source is connected using a cable with a BNC junction plug, use the
41