Argee MSA-004-004 quick start Wizard Setup Procedures

Page 39

Step 2: Wizard Setup Procedures

For this step, you will need your network administrator to provide you the following infor- mation:

•IP range and netmask of machines on the network the Threat Analysis Reporter server will be monitoring

•R3000 IP address, port number to be used between the R3000 and Threat Analysis Reporter, and type of authentication method to be used (IP group or LDAP)

•8e6 Enterprise Reporter server IP address and server name, if an ER unit is con- nected to the R3000

Access the Threat Analysis Reporter Administrator Console

A.Launch Internet Explorer.

B.In the address field, type in http://x.x.x.x:8080/8e6tar/wizard.html (in which “x.x.x.x” represents the eth0 IP address entered in the Connect Network Interface screen

of the Step-by-Step Initial Setup Procedures). In our example, this entry would be: http://200.100.10.10:8080/8e6tar/wizard.html.

C.Click Go to open the Threat Analysis Reporter interface and the EULA Agreement dialog box:

8e6 Threat Analysis Reporter Quick Start Guide

35

Image 39

Contents Guide 8e6 Enterprise Filter Quick Start Guide Contents 8e 6 Threat Analysis Reporter Quick Start Guide Threat Analysis Reporter Introduction Conventions Used in this Document About this DocumentProcedures 8e6 Corporate Headquarters USA8e6 Taiwan Unpack the Unit from the Carton Select a Site for the Server Rack Mount the Server Rack Setup PrecautionsRack Mount Instructions Optional Install the Chassis Rails8e6 Threat Analysis Reporter Quick Start Guide Optional Install the Traditional UP Racks 8e6 Threat Analysis Reporter Quick Start Guide Optional Install the Open Racks 8e6 Threat Analysis Reporter Quick Start Guide 8e6 Threat Analysis Reporter Quick Start Guide Install the Chassis into the Rack Power Supply Precautions Check the Power SupplyServer Operation and Maintenance Precautions General Safety InformationElectrical Safety Precautions AC Power Cord and Cable PrecautionsMotherboard Battery Precautions Monitor and Keyboard Setup Initial Setup ProceduresStep-by-Step Setup Procedures Step-by-Step Setup RequirementsPortion of chassis rear Serial Console SetupHyperTerminal Setup Procedures 8e6 Threat Analysis Reporter Quick Start Guide 8e6 Threat Analysis Reporter Quick Start Guide Login screen, password prompts Step-by-Step Initial Setup Procedures#s3tup#r3k Configure Network Interface screen 8e6 Threat Analysis Reporter Quick Start Guide Configure Domain Name Servers screen Configure default gateway screenConfigure Host Name screen Time zone regional configuration screen Configure Wizard user screen Administration menu Setup Wizard Confirmation screenLog Off, Disconnect the Peripherals System Status ScreenBandwidth Management Physically Connect the Unit to the NetworkAccess the Threat Analysis Reporter Administrator Console Wizard Setup ProceduresLog in to the Threat Analysis Reporter Administrator Console Register administrator 8e6 Threat Analysis Reporter Quick Start Guide 8e6 Threat Analysis Reporter Quick Start Guide R3000 Register R3000 & ER8e6 Threat Analysis Reporter Quick Start Guide 8e6 Threat Analysis Reporter Quick Start Guide 8e6 Threat Analysis Reporter Quick Start Guide Specify Gauge Groups to be Monitored Register GaugesView, Edit Gauge Components Server Settings Conclusion LED Indicator Key Button Key LED Indicator Color Condition DescriptionMSA Units Electromagnetic Compatibility Class a Notice Safety ComplianceDeclaration of the Manufacturer or Importer Electromagnetic Compatibility EMCEC Declaration of Conformity Preliminary Setup Procedures Other Required Installation ItemsUnpack the Ethernet Tap Unit from the Box Install the Ethernet Tap Unit Ports in front panel of NetOptics 10/100BaseT Tap Index