C- CARD THICKNESS CONTROL LEVER
This item is operated by the user to prevent more than one card feeding into the printer at the same time and causing a jam.
Open Cover, and adjust lever to the correct position for the card thickness you are using. Repeat for different card thickness. (Factory setting is for 30mil (0.762 mm) card thickness). See diagram below :
Card thickness:
A - 60mil (1.524mm) to 50mil (1.27mm) B - 40mil (1.016mm)
C - 30mil (0.762mm) D - 20mil (0.508mm)
E* - Less than 20mil (0.508mm)
* Start at lowest position and move lever up to match card thickness.
For other card thickness, start lever at lowest position and move up until cards feed.
D - CARD OUTPUT HOPPER
This item is used for collecting printed cards.
Install Card Output Hopper onto printer by 
hooking over bottom edge of card exit aperture.
OPERATION | 11 |