WARRANTY INFORMATION
WE NEED TO HEAR FROM YOU!
To establish your warranty period and provide access to technical support, send us your warranty registration card today!
Zebra warrants the mechanism, control electronics and power supply, under normal use and service, to be free from defects in material and workmanship for a period of twelve (12) months from the date of purchase by the end user. Zebra warrants the print head, under normal use and service, to be free from defects in material and workmanship for a period of twelve (12) months from the date of purchase by the end user. Proof of purchase or Product registration is required. If proof of purchase or product registration cannot be established, shipment date to the original buyer (dealer or distributor) will be used to establish the warranty period.
Failure to exercise caution to protect the equipment from electrostatic discharge damage, adverse temperature and humidity conditions or physical abuse, including, but not limited to, improper packaging, shipping, service or repairs performed by personnel not authorized by Zebra may void the warranty. Failure to use only Zebra approved media may void the warranty. Zebra will, at its option, repair or replace the equipment or any parts which are determined to be defective within this warranty period, and which are returned to Zebra.
The warranty set forth above is exclusive and no other warranty, whether written or oral, is expressed or implied. Zebra specifically disclaims the implied warranties of merchantability and fitness for a particular purpose.
DECLARATIONS OF CONFORMITY
European Council Directive | Compliance to Standards | |||
|
|
|
| |
89/336/EEC | EMC Directive | EN | RF Emissions | |
control | ||||
modified by |
|
| ||
|
|
| ||
92/31/EEC and | EMC Directive | EN | Immunity to | |
93/68/EEC | 1992 | Electromagnetic | ||
| Disturbances | |||
|
|
| ||
73/23/EEC modified | Low voltage Directive | EN 60950 | Product Safety | |
by 93/68/EEC |
|
|
| |
|
|
|
| |
Model: P420 conforms to the following specification:
FCC Part 15, Subpart A, Section 15.107(a) and Section 15.109(a) Class A digital device
Supplemental Information:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference , and (2) this device must accept any interference received, including interference that may cause undesired operation. Note:
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmfull interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmfull interference to radio communications. Operation of this equipment in a residential area is likely to cause harmfull interference in which case the user will be required to correct the interference at his own expense.
INDUSTRY CANADA NOTICE
This device complies with Industry Canada
Cet équipement est conforme à
iv