Zebra Technologies P110I user manual Loading Cards, Card Feeder

P110i Printer Setup

Loading Cards

Loading Cards

To help you load, print, and collect cards, the P110i has the following items:

Card Feeder

The card feeder is used for loading cards, it can hold up to 100 cards of 30 mils thickness. The card feeder is located under the card feeder cover of the P110i printer.

Caution • DO NOT bend cards or touch print surfaces as this can reduce print quality.

Note • The surface of the cards must remain clean and dust free. Always store cards in an enclosed container. Ideally, use cards as soon as possible. If cards stick together, carefully fan or shuffle them.

Note • For Cards with magnetic stripe refer to Appendix A for loading instructions.

Load cards into card feeder as follows:

1.Open card feeder cover.

2.Slide card guide all the way to the right until it locks in place with an audible click.

CARD FEEDER	CARD
	GUIDE

3.Remove cellophane wrapper from card stack.

Note • Static charges and edge burrs from the card die-cutting process can render individual cards stuck together with significant adhesion force. These cards must be physically separated from each other before inserting into the feeder; if not separated, feeding or printing problems may occur.

980515-001 Rev. A P110i User’s Manual 19