Zebra Technologies GC420t manual 65536k.......B only displays this if installed

ZPL Configuration Status to Command Cross-reference

The configuration settings listed here resume after the TAKE LABEL sensor value. These listings contain printer features seldom changed from default or provide status information (e.g. Firmware Version).

91

Table 3 • ZPL Commands and Configuration Receipt Callout Cross-Reference

Command	Listing Name	Description
^MP	MODES ENABLED	Default: CWF (See ^MP Command)
		(CWFM for wireless printers with display)
	MODES DISABLED	Default: (nothing set)
^JM	RESOLUTION	Default: 832 8/mm FULL (203 dpi)
		1280 8/mm FULL (300 dpi)
—	FIRMWARE	Lists ZPL Firmware Version
—	XML SCHEMA	1.3
—	HARDWARE ID	Lists Firmware Boot-block Version
—	CONFIGURATION	CUSTOMIZED (after first use)
—	RAM	2104k........ R:
—	OPTION MEMORY	65536k.......B: (only displays this if installed)
—	ONBOARD FLASH	1536k.........E:
^MU	FORMAT CONVERT	NONE
^JI / ~JI	ZBI	DISABLED (Requires key to enable)
—	ZBI VERSION	2.1
^JH	LAST CLEANED	X,XXX IN
^MA
	HEAD USAGE	X,XXX IN
~RO
	TOTAL USAGE	X,XXX IN
	RESET CNTR1	X,XXX IN
	RESET CNTR1	X,XXX IN
—	SERIAL NUMBER	XXXXXXXXXXX
^JH	EARLY WARNING	MAINT. OFF

The printer has the ability to set a command or a group of commands once for all receipts (or labels) that follow. Those settings will remain in effect until they are changed by subsequent commands, the printer is reset, or you restore factory defaults.

5/22/2012 GC420t™ User Guide P1052686-001