EM 220
5. Label Printing Function
5-1 Label Function Setting
Label paper and black mark paper available at the label mode.
•Setting Operations
1)Turn on the printer power.
2)Open the paper cover and press and hold down the paper feed button for longer than two seconds.
3)After the buzzer tone is emitted, insert paper and close the cover.
4)Repeat the steps above to return to receipt mode.
•Setting Via Memory Switch
- Please refer to the memory switch changing section of the Commands Manual.
5-2 Auto Calibration Function
The label printing function requires the recognition of label paper gaps and black mark paper black bar in order to print.
If label paper gaps are not properly recognized, use the auto calibration function.
•Auto Calibration Instructions
1)Turn the printer power off while in label print mode.
2)Press and hold down the paper feed button and then press the power button.
3)After the following printout is outputted, press the power button to perform auto calibration.
Select the mode
Auto Calibration: Power Button
Self Test: Feed Button
4) Three pages of label paper are outputted when performing auto calibration.
Rev. 1.00 | - 25 - | Mobile Printer User’s Manual |