Zebra Technologies 2844 user manual Step ➊ Attach Power Supply To The Printer

Page 10

Installation and Operation

Installation The following steps will guide you through the installation of the printer and software.

Step ➊ Attach Power Supply To The Printer

Power OFF

Check Voltage

Plug in

Power

Module

Plug in

Power

Cord

Plug Power Cord

into a Suitable

AC Outlet

See the SHOCK HAZARD WARNING on page iv.

4	980348-001 Rev. A

Image 10

Contents Thermal Printer User’s Manual 2844 980348-001 Rev. a Foreword LP 2844 and TLP 2844 Thermal PrintersShock Hazard Warning Table of Contents 980348-001 Rev. a Installation and Operation Unpack Your Printer Know Your Printer Installation and Operation Step ➊ Attach Power Supply To The Printer Step ➋ Attach Interface Cable Serial ParallelStep ➌ Load Media Power onOpen Cover Open Guides Install Roll Load MediaRelease Cover Close CoverPower OFF Step ➍ AutoSense Media Gap SensingAutoSense Gap Sensor Adjustment Step ➎ Install Software Direct or Transfer? Using Options Step ➊ Prepare Ribbon Step ➋ Install Supply Roll Thread Ribbon Through CarriageStep ➌ Install Take-Up Core Step ➍ Tighten Ribbon Attach Ribbon to Take-Up Core Remove Slack From RibbonPartially Used Push Supply Roll OutUsing the Label Dispenser Open DoorUsing Fan-Fold Media Insert MediaUsing the Media Cutter 980348-001 Rev. a Appendix a Troubleshooting Problem Solution or ReasonRED Troubleshooting Media Handling Host Female DB-25 to Male Centronics Cable For the cable connectors Bus USBPen Across CleaningRub Dark AreaCleaning the Platen Label Rolls Preparing MediaBefore Loading Tag Stock Rolls980348- 001 a